Hello,
I'm having an issue that I can't figure out how to resolve. I have several RDP connections that are configured to use an inherited VPN connection. The VPN connection is a Cisco AnyConnect connection with a macro (Events tab - After Connect section) to handle of the user input that is normally required; it takes quite some time to complete the connection. The problem is that if I initiate the RDP connection without already having a VPN connection established, RDM does not wait for the VPN connection to complete before attempting opening the RDP session. This causes the RDP connection to fail and requires the user to once again open the RDP connection once the VPN connection has completed. This appears to happen with all sessions that use and inherited/existing connection VPN configuration with any type of macro setup. It's obviously a minor issue but it's extremely annoying. I've tried using all the built-in delay values and whatnot provided by RDM but they all implement a delay BEFORE the macro runs which effectively does nothing for me.
Does anyone have any ideas on how to remedy this? Devolutions team, would it be possible to implement some kind of wait for sessions that rely on VPN connections that have macros which run in the "Events - After Connect" section of the VPN configuration?
Thank you!
I'm having an issue that I can't figure out how to resolve. I have several RDP connections that are configured to use an inherited VPN connection. The VPN connection is a Cisco AnyConnect connection with a macro (Events tab - After Connect section) to handle of the user input that is normally required; it takes quite some time to complete the connection. The problem is that if I initiate the RDP connection without already having a VPN connection established, RDM does not wait for the VPN connection to complete before attempting opening the RDP session. This causes the RDP connection to fail and requires the user to once again open the RDP connection once the VPN connection has completed. This appears to happen with all sessions that use and inherited/existing connection VPN configuration with any type of macro setup. It's obviously a minor issue but it's extremely annoying. I've tried using all the built-in delay values and whatnot provided by RDM but they all implement a delay BEFORE the macro runs which effectively does nothing for me.
Does anyone have any ideas on how to remedy this? Devolutions team, would it be possible to implement some kind of wait for sessions that rely on VPN connections that have macros which run in the "Events - After Connect" section of the VPN configuration?
Thank you!